8-Bit Blooper | Super Mario Bros NES Pixel Wall Art Tutorial

A step by step DIY tutorial on how to make 8-bit pixel Blooper from Super Mario Bros. on the classic Nintendo Entertainment System (NES). Display this wall art in your game room and enjoy the 8-bit nostalgia.

Hello everyone, today I’m sharing how to make 8-bit pixel Blooper from the NES version of Super Mario Bros. I created this project on a whim when I noticed I had a scrap piece of 1/2″ plywood sitting on my garage floor. I followed the same technique I used to create 8-bit pixel Link from the original The Legend of Zelda game.

CLICK HERE to view more geeky and nerdy DIY projects.

Related Posts:

• 8-bit Goomba (Super Mario Bros.)
• 8-bit End Grain Goomba (Super Mario Bros.)
• 8-bit Link (The Legend of Zelda)
• 8-bit Cheep Cheep (Super Mario Bros.)
• 8-bit Mario (Super Mario Bros.)
• 8-bit Lakitu and Koopa Troopa (Super Mario Bros)

(For sneak peeks on upcoming projects follow me on Instagram!)

Disclosure: This post contains affiliate links.  That means if you purchase an item via one of these links, I’ll receive a small commission at no added cost to you.  This helps keep the content on the site free and I appreciate the support! :o)

Tools and Supplies

I used the following tools and supplies to create pixel Blooper.

Tools

• Jigsaw or a bandsaw
• Orbital Sander
• Router with 60 degree v-groove bit
• Clamp edge guide
• Kreg Mobile Project Center
• Ruler

Supplies

• 2′ x 2′ plywood – 1/2″ thick
• Acrylic craft paints (black, gray, and white)
• Primer spray paint
• Clear coat
• Sand paper

Watch the video tutorial

Click play and watch the video tutorial below.  The video shows how I made pixel Link, but the general steps remain the same for pixel Blooper. For more woodworking videos, CLICK HERE to subscribe to my YouTube channel.

Continue reading for the written tutorial.

How to make 8-bit pixel Blooper in 5 easy steps

1. Draw 1.5″ grid lines
2. Route along the grid lines
3. Cut out Blooper’s silhouette
4. Prep Pixel Blooper for painting
5. Paint Pixel Blooper

Step 1: Draw 1.5″ grid lines

Use a ruler to mark grid lines space 1.5″ apart.

Step 2: Route along the grid lines

Install a v-groove router bit and route along the grid lines. Use a clamp edge guide to ensure straight lines.

Step 3: Cut out Blooper’s silhouette

Cut out the Blooper’s shape with a jigsaw (or use a bandsaw).

Step 4: Prep Pixel Blooper for painting

Sand between the grooves and sand the surface of Blooper.  I used scrap piece of wood to support the sandpaper as I sanded between the grooves.

Step 5: Paint Pixel Blooper

Paint each pixel on Blooper. Painting between the grooves is a little tricky. Use painters tape to maintain clean lines. I was impatient and used paint brushes for painting miniatures to paint in the crevices.

If necessary, apply multiple layers of paint. Once the paint is dried, protect the finish with a clear coat.

DIY 8-Bit Pixel Blooper

I am really happy with how pixel Blooper turned out.

PIN IT!

FOLLOW ME on Pinterest.